Before Switching On - Premier NV-5516W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16
and 32 . Avoid locating
your Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid direct sunlight in out-
buildings or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or
annex ensure that the Fridge/Freezer is placed above the damp course, otherwise condensation will
occur on the Fridge/Freezer cabinet. Never place the Fridge/Freezer in a wall recessed or into fitted
cabinets or furniture when your Fridge/Freezer is working, the grille at the back may become hot and the
sides warm. It must therefore be installed so that the back of the Fridge/Freezer has at least 9cm(7/2") of
free space and the sides have 2cm(3/4"). Do not drape the Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may cause
you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final location, adjust the
leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing in the Fridge/Freezer. The external parts of the Fridge/Freezer can be
cleaned with wax polish. See page 12 for more details on cleaning.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Fridge/Freezer. If not
see the section called ELECTRICAL INFORMATION on page 11

Before switching on!

DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE/FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your Fridge/Freezer
Before storing foods in your Fridge/Freezer, turn the Fridge/Freezer on and wait for 24 hours, to make
P-4

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Nv-5516bNv-5516ss

Tabla de contenido