Head And Shoulder Support Adjustment; Adjustment Of The Leg Extension; Adjustment Of The Lie-Flat Position (Only Gr. I, 9-18Kg); Seat Location Selection And Adjustment - Kiddy Guardianfix 3 Manual De Uso

EN

4.2 Head and shoulder support adjustment

The correct head support setting is reached when the child's temples are within
the narrowest part of the head support (G).
To adjust the head (G) and shoulder supports (H), actuate the height adjustment
handle (P) on the back side of the head support (G) by gently pulling it outwards
and then sliding the head support (G) up or down depending on the desired
height (Fig. 6).
Ensure that it has correctly engaged by gently pressing down on the head sup-
port (G).

4.3 Adjustment of the leg extension

You can provide significantly better seating comfort for your child by adjusting
the leg extension (K). The leg extension (K) adjustment is continuously variable.
To adjust the leg extension, reach under the cover of the seat (I) and pull or slide
the leg extension (K) to the desired position (Fig. 7).
4.4 Adjustment of the lie-flat position (only GR. I, 9–18kg)
Never adjust the lie-flat or sitting position during travel. For this purpose, stop
your vehicle, open the vehicle's belt, and remove your child.
The lie-flat position may only be used for children of Group I
!
(9–18 kg) in combination with the impact shield and with semi-
universal fastening with the k-fix + connectors.
In order to adjust the lie-flat position, actuate the unlocking handle (R) (Fig. 8,
No. 1) while simultaneously pulling the seat (I) away from the vehicle back rest
(Fig. 8, No. 2). The further you pull the seat forward (I), the greater the angle of
the lying position.
26
The back rest (C) of the kiddy guardianfix 3 pivots automatically to the lie-flat
position. The lie-flat position is reached when the head support (G) of the child
seat is against the back rest of the vehicle seat (Fig. 9).
The maximum lie-flat position is reached when the seat (I) can-
!
not be pulled any further forward.
The maximum angle of the lie-flat position depends on the position of the Isofix
anchorage points in the vehicle.

5 Seat location selection and adjustment

5.1 Adjustment of the vehicle seat

Read all the necessary information about the use of child re-
straint systems (A) in your vehicle owner's manual.
If installation is impeded by a head support, it must be used in the top-most
position or removed (Fig. 10).
With the moving back rest (C) of the kiddy guardianfix 3, it can be assured that
it rests against vehicle seat back rest. Position the adjustable back rest of the
vehicle seat appropriately.

5.2 Seat location for universal installation

The kiddy guardianfix 3 child restraint system (A) can be installed on any seat of
vehicles equipped with a 3-point vehicle seat belt system (Fig. 11).
The kiddy guardianfix 3 can also be used on rear-facing vehicle seats which are
equipped with a 3-point vehicle seat belt system (Fig. 11).
* If the vehicle manufacturer permits child restraint systems on the front pas-
senger seat, the seat should be moved to the rear-most position.
EN
27