Standard Accessories; Battery Removal/Installation - HIKOKI DS 14DSAL Instrucciones De Manejo

STANDARD ACCESSORIES

1 Plus driver bit (No.2) .................... 1
2 Charger (UC18YGSL or UC18YRSL) ..... 1
3 Battery (BSL1830 or BSL1815X) .... 2
DS18DSAL
4 Plastic case ....................................... 1
5 Battery cover .................................... 1
1 Plus driver bit (No.2) .................... 1
2 Charger (UC18YGSL or UC18YRSL) ..... 1
DS14DSAL
3 Battery (BSL1430 or BSL1415X) .... 2
4 Plastic case ....................................... 1
5 Battery cover .................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Battery
(BSL1430)
(BSL1415X)
Optional accessories are subject to change without notice.
Table 1
The pilot Before
lamp
charging
lights or
blinks in
While
red.
charging
Charging
complete
Charging
impossible
Overheat
The pilot
standby
lamp
lights in
green.
(BSL1830) (BSL1815X)
Indications of the pilot lamp
Blinks Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights Lights continuously
Blinks Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
Flickers
seconds. (off for 0.1 seconds)
Lights Lights continuously
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals
Drilling of various woods

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (See Fig. 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (See
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
<UC18YRSL>
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the line
is visible, as shown in Fig. 3, 4.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
English
Malfunction in the
battery or the charger
Battery overheated.
Unable to charge.
(Charging will commence
when battery cools)
10