Wetrok Master Sweep 970 Instrucciones De Manejo página 24

Emptying the waste container
The waste container must be emptied at regular intervals in order to ensure efficient sweeping results. To open the waste container, pull the container
handle (item 6.05) upward. After removing and emptying the waste container, replace it and lock it in by pushing down on the container handle.
Storage
The MASTER SWEEP 970 sweeping machine can be best stored vertically. In this position, the brushes are protected against damage and the wear will
be reduced.
Charging the battery
The battery will be charged with the serial socket battery charger. Attention: charging is only to be carried out in a dry, well ventilated room with turned
off machine. In order to charge the machine, insert the cable into the charging socket of the sweeping machine (item 10.02) and the line cord into a
230V outlet. The LED "Netz" display of the battery charger flashes while the battery is being charged. The LED "Akku voll" display flashes as soon as
the charging process has been completed. After termination of the charging process, the power supply unit must be separated from the mains and the
machine. The complete charging process takes approx. 7-8 hours. Always store the machine with charged battery in order to prevent a total discharge if
the machine is stored without use for a long time. In the case of a long storage time, please recharge the battery from time to time.
Only for the U.S.A. – Charger Typ FW7318M/12
The charger flashes yellow while the battery is being charged. The LED flashes green as soon as the charging has been completed.
Safety instructions for handling the battery
– Only use the provided battery charger.
– Prevent the occurrence of sparks when handling cables and electrical units.
– Never short-circuit the battery poles.
– Always keep batteries clean and dry.
– Do not smoke and keep away unshielded flames and electrical sparks.
– Do not eat and drink in the area of the battery charging station.
– Do not open the battery by force and do not expose it to the sun
– Maximum temperatures: Application: -15° C ~ 50° C
MAINTENANCE
You have chosen a maintenance-friendly product. The customer may only carry out maintenance work described in the following chapter. All other main-
tenance work must be done by an authorized dealer or by the manufacturer. For all maintenance work, the sweeping machine must be turned off and be
disconnected from the mains supply. Maintenance work with running motor is not allowed.
Brushes
The circular brushes, the sweeping roller and the drive system can be cleaned with water.
The brushes are made of polyamide. In the case that the brushes become twisted by inexpert storage, they can be readjusted by means of a hot air
blower (such as a hair-dryer). Please do not use any unshielded flames or burners.
Cleaning of the unit
– Please do not use any high-pressure cleaning systems.
– Clean the machine dry or with a damp cloth.
– Remove grime, threads, hair etc. from the brushes and from the axles.
– Humidity may damage the electrical devices and may cause short circuits.
Charge: 0° C ~ 40° C
Storage: -15° C ~ 40° C
24