HIKOKI ML 34SR Instrucciones De Manejo página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
Troubleshooting
TROUBLESHOOTING
Danger - risk of injury!
Wear working gloves during all maintenance work!
Always unplug from the mains and wait for the blade to stop moving before commencing
any maintenance or preventive maintenance work!
Fault during operation Possible cause
Motor does not run
Reduced motor
performance
Motor stops during
mowing
Grass catcher does not
fi ll up completely
If you encounter any malfunctions that are not listed in this table or which you cannot rectify
yourself, please contact our responsible customer service.
No power supply
Machine cable defective
Cutter blade blocked
Cutter blade is blunt
Too much grass in the
ejector
Cutter blade is blunt
Motor overloaded
Lawn is wet
Grass catcher is clogged
Too much grass in the
discharge chute or
housing
Cutter blade is blunt
Solution
Check fuse / extension lead.
Contact HiKOKI service center
Caution! Do not carry out maintenance
on cutter blade without working gloves!
Free the cutter blade from interference
Start lawn mower on short grass
Have cutter blade sharpened at HiKOKI
service center
Remove grass, clean baffl e plate
Have cutter blade sharpened at HiKOKI
service center
Switch off lawn mower and restart on
level ground or short grass
Allow lawn to dry
Clean the grass catcher grid
Clean discharge chute / housing
Correct cutting height
Have cutter blade sharpened at HiKOKI
service center
en
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ml 40sr

Tabla de contenido