Safety Instructions Initial Use - Parkside PSH 3 A2 Instrucciones De Montaje, De Uso Y De Seguridad

Safety instructions / Initial use
Replace the protective visor if
scratches or damages appear.
The welding helmet does not pro-
vide protection against impact.
Frequent use, cleaning or storage
can mean that the service life is
less than 6 years. Replace the
welding helmet immediately if
the viewing panel gets scratched
or the viewing panel is visibly
damaged in any other way.
ATTENTION! Materials that
come into contact with the wearer's
skin may cause allergic reactions in
people with sensitive skin.
ATTENTION! Eye protection
can represent a hazard for the
wearer if it is worn over normal cor-
rective glasses due to the impact
from high-speed particles.
ATTENTION! If protection
against high-speed particles at
extreme temperatures is required,
the eye protection chosen must be
labelled with the letter T directly af-
ter the letter for the impact intensity,
i. e. FT, BT or AT. If the letter for the
impact intensity is not followed by
the letter T, the eye protection may
only be used against high-speed
particles at room temperature.
18 GB/IE
Initial use
Note: Only use the welding helmet with the rear
pane mounted .
4
Note: Keep the UV filter's sensors
clear.
Check that the welding helmet and the protective
screen are intact before each use. If the protective
screen has scratches, cracks or irregularities, it must
be replaced before use, as serious injuries may oc-
cur otherwise.
Remove the protective film from the inside and
the outside of the visor.
Put on the welding helmet with the help of the
headband . Press the adjustment buttons
5
to make the welding helmet tighter and the ad-
justment button , to fix the welding helmet.
7
When adjusting, ensure that your head is placed
as far into the helmet as possible and that it sits
as close as possible to your face.
Set the appropriate darkening shade before the
welding procedure (see the following table).
The darkening shade may be manually adjusted
from 9 to 13 by twisting the darkening regula-
tor on the outside of the helmet.
9
ATTENTION! The darkening regulator
the setting position "grind". If the darkening
regulator is set to this position the automatic
9
darkening is deactivated.
Only use this setting when you do not wish to
use the welding helmet for welding. The auto-
matic darkening is then no longer active.
Check the light density before each use.
Test procedure: Bring the viewing panel closer
to an external light source with a value of more
than 40 W and examine whether or not the
screen darkens or illuminates.
To change the UV filter / solar cells, push in both
tabs and pull the front frame outward. Fig. B
(Item no. 2000) or loosen the two screws as
shown in Fig. A (Item no. 2001, 2002).
clean and
8
6
has
9