Repair Procedure - Plastimo Light P ISOS Manual Del Propietário

2. Wooden parts should be inspected for damage or deterioration. Surface scratches or abrasions should be covered with a
marine grade varnish.
3. To keep the boat looking new, store the boat in a cool and dry place and avoid excessive exposure to direct sunlight.
IMPORTANT: Waxes or cleaners containing alcohol SHOULD NOT be used on the boat fabric. Alcohol will prematurely dry
out the boat fabric.
4. To avoid damaging the boat during storage, do not place heavy objects on it.
Extended exposure to sunlight or to high temperatures can damage PVC even more if it is coated with a salt layer caused by
evaporation of sea water. It loses its shiny look and turns definitively sticky. In case the tender is exposed durably to sunlight,
on davits for example, it is recommended to rinse it regularly with fresh water, to slightly deflate it -to avoid overpressure and
to damage pasting- and to use a protection cover. The same cautions are recommended for Hypalon even if it is more
resistant to sunlight.
Normal full inflation pressure is 0.25 bar for the tube and 0.35 bar for the keel, 0.60 bar for the inflatable floor and 0.80
bar for the fixed floor (P240LJ, PI230VB, PI270VB, PI320VB, PI350VB ). If the boat is inflated when at sea level (low
altitude) and is brought to a high altitude (i.e. for use in a mountain lake), the air pressure must be reduced at the higher
altitude to prevent over-inflation.
1. The repair of a small leak or puncture less than ½ inch (12.7 mm) can be done with a round patch, 3 inches (76.2
mm) diameter, minimum.
2. Both patch and surface on the boat must be dry and free of dirt and grease.
3. Apply 3 thin, even coats of adhesive to the surface of the boat and the patch. Wait 5 minutes between each coat. After
the 3rd coat, wait 10-15 minutes before placing the patch on the boat skin.
4. Wait for at least 24 hours before re-inflating the boat.
For Hypalon boats, the repair procedure is explained in the leaflet included in the repair kit.
LARGE REPAIRS OF SKIN, SEAMS, BULKHEADS AND TRANSOM
For all large repairs it is recommended to return the boat to your dealer. Contact him first, if possible.
Lubricate the valve stem with silicone or soapy water to facilitate installation.
37295_03.cdr
25 novembre 2008
EXPOSURE TO SUNLIGHT OF PVC TENDERS
USE IN HIGHER ALTITUDES

REPAIR PROCEDURE

SMALL TEARS, CUTS AND PUNCTURES
INSTALLING NEW CHECK VALVES
9
GB