Preparing The Machine For Use; Filling The Solution Tank; Before Using; Pre-Spraying The Carpet - U.S. Products AGITATOR Serie Instrucciones De Uso

A-8 / ENGLISH

PREPARING THE MACHINE FOR USE

FILLING THE SOLUTION TANK

1 Turn the Power Switch (15) to OFF (O) and then unplug the machine.
2 Remove the Solution Tank Lid (5).
3 Read the dilution instructions on the chemical container. Then calculate the proper amount of chemical to mix with your machine's solution tank
capacity of water. 18" models: 13 gallons (49.21 liters) / 16" model: 8 gallons (30.28 liters).
4 See Figure 4. Pour the chemical into the Solution Tank (9) and fi ll the tank with hot water (maximum temperature 54°C/130°F). NOTE: Do not
overfi ll the solution tank. The maximum fi ll point is when the solution level reaches the bottom of the Lip (A) on the front of the tank opening.
Agitator™ 18 Clean & Restore: Fill the Chemical Bottle (13) on the rear of the machine. Do not pour any chemical into the solution tank.
5 Reinstall the Solution Tank Lid (5).
CAUTION!
FIGURE 4
BEFORE USING THE AGITATOR
Thoroughly vacuum the carpet to be cleaned before using the Agitator

PRE-SPRAYING THE CARPET

Pre-spray spots and heavy traffi c areas before extracting. Use a hand-held bottle sprayer or a pressurized "Hudson" type sprayer. Mix the pre-spray
according to the chemical manufacturer's directions.

PLAN FOR CLEANING

Before you begin extracting, look at the area to be cleaned and plan your work. Divide the space into sections. Overlap each pass 2 inches (5 cm).
A-8 - FORM NO. 56041707 - Agitator
EN
Use low-sudsing, liquid detergents designed for carpet extraction.
™
16 / 18 Clean & Restore
™
automatic extractor.
™