Whirlpool CSXD26VW Instrucciones De Instalación

Attention Installer
1. Prepare Location
• Make sure cutout floor is level. If floor is not level it is
necessary to shim rear wheels onto a piece of plywood
or other shim material so refrigerator is level.
!
To avoid electrical shock which can cause severe personal
injury or death, disconnect power to refrigerator before
removing doors. After replacing doors, connect power.
2. Prepare refrigerator for delivery
Some installations may require door removal to get
refrigerator
into home.
1. Remove toe grille
2. Remove top hinge cover and top hinge.
Dispensing and Electronic Models
!
To avoid electrical shock which can cause severe personal
injury or death, green ground wire must remain attached to
hinge.
• Disconnect wire connectors (A).
Loosen water tube clamp (B). Loosen water tube union
nut (C). Pull water tube away from union nut and
through tube clamp.
• Unplug electrical connector from voltage box (D).
3. Remove doors (E).
• Remove top hinges (F).
• Remove doors from bottom hinge (F).
• Remove bottom hinge (F).
!
To avoid floor and wall damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective material
when moving refrigerator.
4. Attach refrigerator to appliance cart (G).
3. Install refrigerator
1. Reinstall doors by performing section 2 in reverse order.
2. Connect ice maker water supply line (Refer to Installation
Instructions in Owner's Manual .)
3. Plug power cord into electrical receptacle.
4. Stabilize refrigerator and align doors.
If refrigerator rocks or is not stable on floor perform
the following:
• Determine which rear corner is rocking.
• Remove toe grille to gain access to roller adjustment
screws.
• Turn rear roller adjustment screw (A) clockwise to raise
corner that is rocking.
• Check alignment of top of doors. If doors are level replace
toe grille.
If tops of doors are not level perform the following steps:
• Determine which door must be raised (if toe grille has not
been removed, remove at this time).
• Turn front roller adjustment screw (B) clockwise to raise
front corner of door that needs to be raised. Roller adjust-
ment screw should be turned until doors are level (C).
• Replace toe grille.
4. Prepare refrigerator for use
1. Remove all interior packaging material
3. Instruct consumer on controls and features.
The manufacturer cannot be responsible for improper installation.
WARNING
WARNING
CAUTION
A
D
Top left
F
Bottom
left
Copper
tubing
2. Clean interior and exterior of refrigerator
4. Verify power to refrigerator is connected.
Shim refrigerator
wheels as needed
C
B
E
Top right
Bottom
right
G
"P" clamp
Brass nut
Brass sleeve
Water valve
inlet connection
C
A
B