Moon Phase - nedis WEST204WT Manual De Uso

7. MOON PHASE

It will calculate the moon phase automatically, the moon phase being divided into
8 degrees.
Temperature and Humidity:
1. Temperature range indoors: 0 °C~50 °C (32 °F~122 °F);
Temperature range outdoors: -50 °C~70 °C (-58 °F~158 °F).
2. Range of humidity: 20%–99%.
3. Tendency of temperature change: one check per hour, compared to previous data. If the
temperature changes more than 1 °C the arrow will be flat.
Pressure and Weather Forecast:
1. Turn on power to set the height, or it will be 0.
2. Two kinds of pressure units: Hpa/Mb or in Hg.
3. Records the pressure data of the past 12 hours.
4. Compares the pressure data with the previous data every 60 minutes. If the change is
more than 2 hpa the pressure arrow will change.
5. Checks data every hour and will display the weather graphics according to the result.
RCC Reception Mode:
1. RCC reception format: DCF, the reception time is about 10 minutes.
2. RCC reception way.
3. It will begin to receive the RCC 3 minutes after turning on the unit.
4. RCC reception graphic:
The tower graphic flashes when receiving, the tower graphic will also flash when lost or
has no signal. The tower graphic will not flash when synchronizing the signal, but the arc-
shaped antenna symbol on top of the tower graphic is flashing. The whole RCC reception
graphic will display when the reception is successful: The tower graphic will turn off and
exit RCC when the signal reception fails.
Part II
There are 5 buttons at the rear: UP, DOWN, HISTROY, MAX/MIN, ALERT. These buttons are
used for the following functions:
1. ALERT Button
While in normal display mode, press this button to activate or deactivate the temperature
alert function. An arrow icon will appear to indicate the funcion has been activated, or
the arrow icon will disappear to indicate the alarm is deactivated.
While in normal display mode, press and hold this button for 3 seconds to enter the
temperature alert settings. The door temperature digits will start flashes. Press the ALERT
button at the rear to set the temperature (0 °C~50 °C) at which the statio nhas to sound
an alarm.
2. UP Button at the rear
In normal display mode press this button to select pressure unit between Hpa/Mb or Hg.
In normal display mode press and hold this button for 3 seconds to enter weather
forecast display mode, select by pressing the DOWN button (at the rear) among sunny,
cloudy, rainy, etc.
3
ENGLISH