Power Dynamics 179.114 Manual De Usuario página 8

RECEIVER OPERATION INSTRUCTION (CHANNEL DATA SETTING)
1. Turn on the receiver
Length press
2. Channel Set Up: Press Up and Down button 10 select the channel data.
2.1 Length press "MANU" 10 enter channel setting mode, the figure is flashing, during three
seconds after operation is finished. the system will lock and save the message and then exit.
2.2 Length press "AUTO" to enter Automatic searching mode, when the usable channel is found,
it will be lock and save, and then exit.
Att: When use the "AUTO" mode, the transmitter must be turned on.
NOTE: Overpass the channel setting, the receiver's data is finished, Data will be retained until the
receiver is reset.
OPERATION INSTRUCTION
Turn on the transmitter
1. Length press the power button 10 turn ON/OFF the transmitter, short press the "POWER"
twice, it is turn ON/OFF the MUTE status.
2. Length press "up" to enter frequency selling, the figure is flashing, short press "DOWN", setting
channel to make consistent with the receiver after three seconds it will be exit automatic. Length
press "DOWW, it will show the exchange of frequency and channel.
3.Backlight will light when there are some action for the button, the light will crush out
when the operation is finished.