JBSYSTEMS Light SCANMASTER 1612 Manual De Instrucciones página 6

ENGLISH
SET UP
1. FIXTURE SETUP: SM-1612 has 12 "fixtures buttons". Each fixture button
represents 16 DMX-addresses. (8faders on page A and 8faders on page B) In
most cases SM-1612 will be used with fixture having 8 or less DMX addresses.
This means that in most cases only page A will be used.
The following chart helps you setting up the DMX-start address on your fixtures:
Fixture #
2. JOYSTICK SETUP: For each fixture any 2 addresses can be assigned to the PAN
and TILT of the joystick:
• Press and hold the "Program" button until its LED blinks.
• Press 2 times the "Mode" and "Fine" buttons at the same time. The assign LED
should light. (if reverse LED is lit, press both buttons a second time together)
• Use the bank UP and DOWN keys to select the axis you wish to assign (PAN or
TILT).
• If your fixture has more than 8 DMX addresses, you can use the "Tap/Display"
button to select 16 or 8 channel mode.
• Press the button corresponding to the fixture you wish to edit.
• While holding the mode button press the scene number corresponding to the
slider which controls the movement. (Example: If pan is controlled by slider
number 4, press and hold the "Mode" button while pressing scene button 4).
• When both PAN and TILT are assigned, press the "Mode" and "Fine" buttons at
the same time again to exit Assign mode.
Note: you can still use the channel faders instead of the joystick to control the
movements of the fixture.
3. DELETE JOYSTICK SETUP FOR A FIXTURE:
Enable Programming Mode.
•
• Press 2 times the "Mode" and "Fine" buttons at the same time. The assign LED
should light. (if reverse LED is lit, press both buttons a second time together)
• If your fixture has more than 8 DMX addresses, you can use the "Tap/Display"
button to select 16 or 8 channel mode.
• Press the button corresponding to the fixture you wish to edit.
• While holding the mode button, press the "Auto/Del" button.
• Press the program button for some seconds to stop program mode
JB SYSTEMS
Digital Setting
1 1
2 17
3 33
4 49
5 65
6 81
7 97
8 113
9 129
10 145
11 161
12 177
(Press and hold the "Program" button until its LED blinks)
Dip Switch Setting
1 "On"
1 and 5 "On"
1 and 6 "On"
1,5 and 6 "On"
1 and 7 "On"
1,5 and 7 "On"
1,6 and 7 "On"
1,5,6 and 7 "On"
1 and 8 "On"
1,5 and 8 "On"
1,6 and 8 "On"
1,5,6 and 8 "On"
5/68 SCANMASTER 1612 (SM-1612)
OPERATION MANUAL