Using Mobile Devices - Schluter LIPROTEC LT EBR 1 Instrucciones De Uso

EN
Operation
3.1.2 Connecting additional remote control to receiver
If you wish to use any remote controls additional to the
supplied remote control, you must first connect them with the
Bluetooth receiver. Proceed as follows:
Disconnect the Bluetooth receiver's power supply.

Reset the power supply and within five seconds, press

both the "on/off" button and "down" arrow button on the
remote control, which should be connected to the
Bluetooth receiver (see fig. C, pos 2 and 4).
The remote control and Bluetooth receiver are now

connected. You can the switch the light with the
"on/off" button and access the saved preliminary
settings with the arrow keys.
3.1.3 Connecting replacement remote control with the
receiver
To connect a replacement remote control to the Bluetooth
receiver instead of the one supplied, proceed as follows:
Start the SCHLÜTER app on your mobile device.

Go to the "Configuration" screen.

Cancel the connection to the old remote control there.

Operate as described in chapter "Connecting additional

remote control to receiver".

3.2 Using mobile devices

3.2.1 Connecting mobile device with the receiver
You can remotely control and programme the Bluetooth
receiver over a Bluetooth connection. You can additionally
22 Bluetooth receiver operating instructions