Learn Mode - Sure Flap MICROCHIP CAT FLAP Manual De Uso

6. Learn Mode

To start operation, first SureFlap
microchip. This process is only required once for each cat, as the code is permanently
stored even if the batteries are removed. Follow the simple step-by-step guide below to
carry out this process:
1) Initially the unit will be locked and no cat will be allowed to enter the house. Make
sure the manual lock is set to position 1, allowing the door to open freely. See
figure 19.
2) Remove the battery cover. Press the memory button for around 1 second and
release. See figure 20.
3) The catch will open, allowing a cat to pass through the flap in either direction. A
further indication that the unit is in learn mode is the indicator lamp which will
flash every second. See figure 21.
4) The next cat to pass through the flap from either direction will be remembered if
they have a microchip implant.
5) Once a cat has been successfully learnt, the flap reverts back to normal
operation. The indicator lamp stops flashing and the catch will close a couple of
seconds after they have passed through the flap.
For multiple cats, repeat the process until all cats have been learnt. Up to 32 different cats
may be held in memory at once. Replace the battery cover after all cats have been learnt.
This method of learning is particularly convenient for uncooperative cats! Rather than
having to find your cat and pass them through the flap, you can simply set to learn mode
and leave until he next decides to go through of his own free will.
To cancel learn mode (e.g. after pressing the memory button accidentally) simply press the
memory button again for around 1 second and the unit will revert back to normal operation.
In order to learn a cat, it is important that they pass through the flap. There is a
sensor that detects the cat‟s presence in the tunnel that needs to be triggered
and no amount of waving your cat in front of the flap will have an effect.
®
needs to learn the unique ID code of your cat‟s
Page 12