Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Please read all these instructions BEFORE fitting the SureFlap cat flap. Importantly, please
checkwhether there is metal in the substrate the flap is to be fitted into.Please follow the
metal mount instructions if this is the case.
Every effort has been made to ensure the SureFlap will operate with all 9, 10, and 15-digit
microchips that are commonly used for pet identification. However, there are a small
number of circumstances relating to the position of your pet‟s microchip and the signal
strength of the individual chip, which may mean that the cat flap does not operate reliably.
We therefore strongly advise that the following checks are carried out before permanent
changes are made to a door for mounting the cat flap:
1) Insert batteries and leave for 10s with nothing in the tunnel so the sensors can
settle.
2) Press the „memory‟ button and persuade your cat to put their head up to the door
from the tunnel side. The indicator light will stop flashing when their chip has
been learnt.
3) Leave the flap until the lock closes again.
4) Finally, test the normal operation of the flap. Again persuade your cat to put their
head up to the door from the tunnel side. Try to make sure this is similar to how
they would use it in practice, as shown below. The catchshould open.
5) Repeat the learn process for each of your cats.

Important Notice

Page 1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido