Honeywell ES800 Serie Manual De Instrucciones página 6

USE & OPERATION (CONTINUED)
FILLING WITH WATER & ICE
CAUTION:
Remove the power adapter and cord from the unit and the electrical outlet before emptying or
refilling the water tank. Wait for 2 minutes before removing the Water Tank to allow any excess water
in the Honeycomb Cooling Media to drip into the tank before removing it.
Note: After removing the tank, water from the Honeycomb may continue to drip and collect in the
tank compartment. Simply wipe dry with a clean, dry cloth.
Slide out the Water Tank. Refill the tank when water level is low. Do not fill
water above the "Max." water level mark to avoid water droplets collecting
on the louvers. Check the water level in the tank before running the
COOL function. The Low Water Alarm will sound when water is low.
Running the unit in COOL mode with inadequate water may cause pump
failure.
If ice is available, you may add ice in the top ice compartment to enhance
the cooling performance.
Note: The water capacity refers to the total volume of water that can be
contained within the air cooler water tank and water distribution system.
The water capacity in the tank at the "Max." indicator level may be lower
than the actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and
Honeycomb media.
WATER FILTER*
Some models are equipped with a water filter in the tank, which helps to
filter dust, hair and other particles from entering the water tank. Simply
pour water over the filter when refilling the tank.
To clean the water filter, simply push the bottom of the filter cup upwards
to release from the filter frame. Remove dust and hair from the filter
sponge and rinse under clean water. When clean, replace the sponge
and secure the filter cup back into the frame.
*Applicable for models with water filter feature only.
EN 5
Front water fill door
for easy tank refill
Ice Compartment
Water
Filter
Filter Cup