Bestron AHD1400P Manual Del Usuario página 16

storing it after use.
• Do not touch the appliance if it has fallen into water. Remove the plug from
the plug socket immediately. Do not use the appliance anymore.
operAtion - general
The appliance is intended only for domestic use,
not for professional use.
1. Mouthpiece
2. On/off switch 0-1-2
3. Grid
4. Hinge
5. Hang up loop
6. Power cord and plug
operAtion - Before use for the first time
1. Remove the packaging.
2. Clean all the accessories to remove any residues that may be left from the manufacturing process (see
"Cleaning and maintenance").
The appliance may emit a characteristic smell when you switch it on for the first time. This is
note
normal and will stop on its own. Make sure there is sufficient ventilation.
operAtion - use
1. Make sure that the On/Off switch of the appliance is set to 0 (Off).
2. Insert the plug in the wall socket.
3. Put the On/Off switch (5) on 1. Or for a harder blow power on 2.
Don't put the mouthpiece too close to the hair when the heat switch is on level 2. This way you can
damage your hair.
tip In case of real wet hear, it is better to start with drying on a higher level. Switch the hair dryer on to a
less hot level as the hair become dryer.
tip To give your hair more volume, you should dry your hair piece by piece from the beginning of the hair
and pull up. Start blowing just above the hair. This way your hair will easily stay upward. And so get
more volume.
tip You can get more volume by blowing up against the hair till it is almost dry. After that blow in the right
direction.
tip Dry your hair in front of the mirror is often a difficult task. Just try without looking in the mirror. Bend
your head a little bit forward so you can see what your doing. You will see, it works quite good!
tip Always keep moving when blowing your hair dry to prevent overheating and so damage the hair.
Never close the back of the appliance. This way it can overheat.
1
2
5
16
instruction manual
4
2
1
0
6
Figure 1
3