Media; Ribbon - Toshiba TEC B-570-QP Serie Manual De Instrucciones

2. SPECIFICATIONS

2.3 Media

I
Stop
position
Cut
position
J
H
Item
A : Span of one label/tag
B : Label/tag length
C : Width including backing paper
D : Label width
E : Gap length
F : Black mark length (Tag paper)
G : Effective print width
H :
Effective print
length
I : Print speed up/slow down area
J : Black mark length (Label)
Maximum effective length
for on the fly issue
Outer roll diameter
Thickness
NOTES: 1. The media specification other than above are unchanged.
2. When marking black marks on label rolls, the following requirements must be satisfied.

2.4 Ribbon

Type Spool type
68 mm ~ 134 mm
Width
600 m
Length
Outer diameter ø90 mm (max.)
Label
Reference
coordinate 1
Reference
coordinate
2
G
D
C
Label dispensing mode
Label Standard
Max. memory
TAG Standard
Max. memory
Standard
Max. memory
Label
Tag
When the gap length is less than 4 mm:
The black mark length should be longer than the gap length.
When the gap length is 4 mm or more:
The black mark should not overlap the gap for more than 4 mm and the following label.
NOTES: 1. "On the fly issue" means that the printer can draw and
Refer to the following
NOTE 2.
Black Mark
(on reverse side)
I
Stop
position
E
Cut
position
A
H
B
Feed direction
Fig. 2-1
Strip mode
Batch mode
10.0 ~ 999.0 25.4 ~ 999.0
8.0 ~ 997.0
23.4 ~ 997.0
50.8 ~ 140.0
47.8 ~ 137.0
2.0 ~ 20.0
2.0 ~ 20.0
2.0 ~ 10.0
10.0 ~ 128.0
6.0 ~ 298.6
21.4 ~ 298.6
6.0 ~ 995.0
21.4 ~ 995.0
8.0 ~ 298.6 23.4 ~ 298.6
8.0 ~ 997.0
23.4 ~ 997.0
Refer to the following NOTE 2.
149.3
661.3
ø200 Max.
0.13 ~ 0.17
0.15 ~ 0.29
print without stopping between labels.
2. To ensure print quality and print head life use only
TOSHIBA TEC specified media and ribbons.
3. When using the cutter ensure that label length B plus
inter label gap length E exceeds 35 mm. (i.e. label
pitch should be greater that 35 mm.)
4. When rewinding the media onto the take-up spool in
batch mode, the max. outer roll diameter should be 180
mm.
5. Use of rough media for the ribbon saving issue may
cause ribbon smudges.
E2-2
ENGLISH VERSION EM1-33031
Tag paper
Black Mark
(on reverse side)
Reference
coordinate
1
Reference
coordinate
2
G
C
[Unit : mm]
Cut mode
Label: 38 ~ 999.0
Tag: 25.4 ~ 999.0
25.0 ~993.0
6.0 ~ 20.0
23.0 ~ 298.6
23.0 ~ 991.0
234.0 ~ 298.6
23.4 ~ 997.0
1.0
2.3 Media
Tag paper
F
A