Charging The Battery - O'Barber TO50 Manual De Usuario

EN
3 Use

3.1 Charging the battery

It is essential to charge the battery for about 16 hours before using the clippers for
the first time.
Charge the clippers at least once during the year following the date of delivery.
The battery reaches its full capacity after 3 or 4 charging/discharging cycles and its
charging time is then about 2 hours.
 Use only the HX-G35045100 power pack (see Fig. 1-E and § 5).
 When charging, it is recommended to switch off the clippers (On/Off
button set to 0, Fig. 1-B).
Charging the battery on the charge stand
 Insert the electrical lead into the charge stand socket (Fig. 3).
 Connect the power pack (Fig. 1-E) to a mains power socket.
 Put the clippers on the charge stand The indicator light (Fig. 1-D) comes on.
 Comply with the recommended charging time (about 2 hours); the indicator
light stays on while the clippers are on the stand.
3.2 Operation
When first used, lubricate the blades by applying a drop of oil to the points shown
(Fig. 5b).
Switching on/off
 Switch the clippers on (On/Off button set to 1 (Fig. 1-B)).
 To switch the clippers off, set the On/Off button to 0 (Fig. 1-B).
Autonomy
 With a new, fully charged battery, the clippers can be used for about
50 minutes.
 Charge the clippers when the motor speed starts to fall (refer to § 3.1).
24