Using The Comb Attachment - O'Barber TO50 Manual De Usuario

3.3 Using the comb attachment

 The clippers must be switched off. Put the comb attachment on the blades
(Fig. 4a).
 Slide the comb attachment up or down on the blades: 4 slots (Fig. 4b). This
varies the cutting height between 3 and 6 mm.
 To remove the comb attachment from the blades, release the clip and slide it
towards the front of the blades (Fig. 4c).
3.4 Lubricating the cutters
After 30 minutes of use, it is recommended to lubricate the cutters.
 Switch the clippers off.
 Remove the blades (Fig. 5a) using the spanner stored under the power pack
(Fig. 1-G).
 Apply 1 drop of lubricating oil to the 4 points shown (Fig. 5b).
Use only the oil supplied.
 Refit the blades (Fig. 5c). Put the spanner back in its housing under the power
pack (Fig. 1-G).
 Switch the clippers on for a few seconds after lubricating them.
4 Servicing
4.1 Routine servicing
 After using the clippers each time, clean the cutters with the brush supplied
(Fig. 1-I).
 If necessary, clean the body of the clippers with a cloth slightly dampened with
water or mild liquid soap. Never use abrasive products or solvents.
 Clean the blades with an antibacterial spray. We recommend STERIL CLEANER
920- or 921- disinfectant, lubricant and cooling products.
 Lubricate the cutters at least once a day (see § 3.4).
25
EN