Troubleshooting - AudioSonic CL-480 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
• Now press and hold the alarm set button and simultaneously press the min
set button to set the desired alarm minutes. Press and hold the button for fast
setting or tap it briefly to increase the setting by one minute.
• Now press alarm on/off, the alarm indicator lights on the display. The radio will
turn on to wake you at the preset time with your favorite station. It will play for 1
hour and then automatically turn off.
• For alarm with your favourite station set alarm radio/buzz to radio.
• To wake to buzzer instead of radio, make sure to turn alarm radio/buzz to buzz.
• Press alarm on/off to turn off radio or buzzer, the alarm indicator turns off.
• The alarm will come on the next day at the same time.
snooze Function
• When the buzzer sounds or the radio turns on, press snooze to turn off buzzer or
radio temporarily. Approx. 5 minutes later buzzer or radio will sound again.
• The snooze function is repeated up to one hour or until you cancel it by pressing
the alarm on/off button. After 1 hour the snooze function is automatically reset.
sleep to radio
• Select the desired radio station and volume level.
• Press the sleep button to access the sleep timer; the display shows 90 and SLEEP.
Repeatedly press sleep to adjust the sleep time to 90, 60, 30, and 10 minutes, the
corresponding time is displayed and SLEEP flashes for a few seconds. The display
returns to the frequency and SLEEP is displayed.
• The radio will play for the set period and then turn off automatically.
• To turn the radio off prior to the end of the preset period, simply press the
snooze button.
sleep to radio and Wake to radio or Buzzer
• Select the desired radio station and volume level.
• Press the sleep button and set the desired sleep period as described above.
• Set the alarm as described above.
• The radio turns off after the preset time and wakes you the next morning with
buzzer or radio, according to your setting.

trouBleshootIng

If a fault occurs, first check the points listed below before taking the unit for repair.
If you are unable to solve a problem by following these tips, consult your dealer or
authorized service center.
WarnIng: Never open the device. Always refer service or maintenance to
authorized customer service personnel.
problem
reason
No Sound
Volume is set too low.
Mains power supply is
not connected.
Key malfunction.
Electrostatic charge.
Poor reception.
Weak signal. Interference
from other electric
appliances (TV, VCR,
Computer, etc.).
EN
Instruction Manual
solution
Adjust the volume.
Connect the power
cord to the wall outlet.
Turn the unit off and
then back on.
Alternatively, turn off
the unit, disconnect the
AC power cord and the
back-up battery and
then re-connect it.
Adjust the antenna.
Keep distance to other
electrical
appliances.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido