CONTROL PANEL
140
lower
100
warm
INITIAL USE
Unpack the package, take out all the accessories and clean them according to the section of
"CLEAN AND MAINTENANCE".
ASSEMBLE THE GRILL PLATES
Normally, the grill is opened at an angle of 105 degree as shown in Fig.1. The top grill plate
can be level with the bottom to create a large cooking surface and assemble the top grill plate.
First open the grill to an angle which is less than 105, then push the lift lever upwards with the
other hand and hold the handle with one hand to open the grill to 180 (see fig.2). Insert the
plates into the holes near the hinge and push down the front end of the plate with a little force
to snap the plate into place(See Fig.3). Then close the grill, just pull the handle directly
towards you.
OPERATION
A: Grill
1. Prepare all garnish(cucumber, tomato etc.)
2. Cut food (meat, beef and so on) to be grilled no more than 10mm thick.
3. Make sure the drip box is placed on the table and under the grill assemble during
operation, so it can collect the oil residues flowing out from the grill plates (see fig.4).
4.
Then lift the handle and push the handle backwards to open the grill.
5. Wipe the grill plate with a little oil or butter, and then close it. Do not use low fat for
spreading, as it may result in the food burning.
Note: the striation surface is only suitable for grilling meat, take care the quantity of food
is proper.
6. Make sure the temperature knob is set at the minimum of "
closed (see fig.4).
7. Plug the power cord into the socket.
180
medium
220
Power
hi
h
g
off
riddle
g
Ready
rill
g
"position and the grill is