Surface Mounting; Wall Mounted - Gama Sonic GS-334 Manual De Instrucciones

Assembly Instructions
Ground Mounting
1. Assemble the mounting poles (B, C and D) and Stake (E);
(as shown in figure 1).
NOTE: there are 3 optional heights to use for your convenience.
2. Carefully insert the stakes into the ground where desired.
NOTE: If the ground is hard and packed, moisten the ground with water
before inserting the stake (to avoid breakage). Use a rubber mallet (not
included), if necessary, to gently tap stake into ground.
3. Slide the lamp unit (A) into the upper part (B) carefully.

Surface Mounting

1. Fix the base (F) to a solid, flat
surface using the screws provided
(as shown in figure 2-1).
2. Slide the lamp unit (A) into the base
(F) carefully.
NOTE: You may use the solar light
as a free standing product as shown
in Figure 2-2.
Figure 2-1 Figure 2-2
Free standing
Operation
1. Detach the top cover (H) from lamp unit (A) by twisting it Counter-
clockwise, as shown in figure 4.
2. Adjust the switch located near the battery compartment to "AUTO"
position.
3. Reassemble the unit by reversing the above procedure.
NOTE: The solar light must be charged for two sunny days for best
results.

Wall mounted

1. Join the 2 parts of wall bracket (G)
using the screw provided (as shown
in figure 3).
2. Fix the wall bracket to the wall using
the screws and nags provided.
3. Carefully slide the lamp unit (A) into
the wall-mounted bracket (G).
Figure 3
Figure 4
Switch
3
Figure 1