Operating The Spray Gun; Pressure Relief Procedure; Spraying; Spraying Technique - SprayTECH EP2205 Serie Manual Del Propietário

Operating the Spray Gun

WARNING
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.

Pressure Relief Procedure

WARNING
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for cleanup.
1. Lock the gun by turning the gun trigger lock to the locked
position.
2. Move the ON/OFF switch
to OFF.
3. Turn the pressure control
knob counterclockwise to
its lowest setting.
4. Turn the PRIME/SPRAY
knob to PRIME.
5. Unlock the gun by turning
the gun trigger lock to the
unlocked position.
6. Hold the metal part of the gun firmly to
the side of a metal container to ground
the gun and avoid a build up of static
electricity.
7. Trigger the gun to remove any
pressure which may still be in the
hose.
8. Lock the gun by turning the gun trigger lock to the locked
position.
WARNING
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.
© SprayTECH. All rights reserved.
Pressure Control Knob
5

Spraying

NOTE: When spraying block filler, mastics or high
solid coating, leave out the gun filter and high
pressure filter screens.

Spraying Technique

The key to a good paint job is an even coating over the entire
surface. This is done by using even strokes. Keep your arm
moving at a constant speed and keep the spray gun at a
constant distance from the surface. The best spraying
distance is 10 to 12 inches between the spray tip and the
surface.
Even coat throughout
Keep stroke smooth and at an even speed.
Keep the spray gun at right angles to the surface. This means
moving your entire arm back and forth rather than just flexing
your wrist.
Light Coat Heavy Coat
Do not flex wrist while spraying.
Keep the spray gun perpendicular to the surface, otherwise
one end of the pattern will be thicker than the other.
Approximately
10 to 12 inches
Right way
Wrong way
Approximately
10 to 12 inches
Light Coat
English