Functional Description - Delta DC-580 20" PLANER 22-450 Manual De Instrucciones

POWER CONNECTIONS
A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should
be protected with a time delay fuse. NOTE: Time delay fuses should be marked "D" in Canada and "T" in the US. If
an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and matching
receptacle which will accept the machine's plug. Before connecting the machine to the power line, make sure the
switch (s) is in the "OFF" position and be sure that the electric current is of the same characteristics as indicated on the
machine. All line connections should make good contact. Running on low voltage will damage the machine.
Do not expose the machine to rain or operate the machine in damp locations.
MOTOR SPECIFICATIONS
Your machine has a 5HP motor that is wired at 220 volts and 60 HZ alternating current. It may be wired for three
phase or single phase operation - check the spec plate on the motor.
gROUNDINg INSTRUCTIONS
Permanently connected machines:
If the machine is intended to be permanently connected, all wiring must be done by a qualified electrician and
conform to the National Electric Code and all local codes and ordinances.
* THREE PHASE OPERATION: Three phase machines are not supplied with a power cord and must be permanently
connected to a building's electrical system. Extension cords can't be used with a three phase machine.
* LVC MAgNETIC MOTOR CONTROL: If you purch-ased a machine that has a Low Voltage Magnetic Motor Control
System, refer to its instruction manual for installation guidance.
FOREWORD
The Delta Model 22-450 (DC-580) 20" Planer has a 3-phase, 5HP motor with an LVC magnetic starter and automatic
reset overload protection; 3-knife cutterhead, sectional serrated infeed roll, double bed rollers, and polyurethane
outfeed roller, sectional chipbreakers, dust chute, knife-setting gauge, and wrench. The Delta Model 22-451 (DC-580)
20" Planer is the same as above except with a single-phase, 5HP motor.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.
UNPACkINg AND CLEANINg
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

FUNCTIONAL DESCRIPTION

5