Pentair Flotec DIGIPRESS Manual De Uso Y Manutención página 16

EN
USE AND MAINTENANCE MANUAL
BUTTONS STATUS
click!
hold
click!
3"
click!
3"
click!
3"
CHAPTER 5
OPERATIONAL CHARACTERISTICS
• Control of start-up for operation
and adjustable stop.
• Integrated digital pressure gauge
with reading in bar and psi
• Integrated pressure transducer.
• Protection against dry running.
• By instantaneous absorbed
current.
• Protection against current
overintensity.
• ART (Automatic Reset Test)
function. When the device
is disconnected due to
14
ACTION
From status ON: device OFF.
From status OFF: the device starts operating and the
pump is activated until "Stop pressure With any of the configuration modes: valid the value
introduced.
From status ON: device OFF.
From status OFF: the device continues operating until the
Display "Start pressure" for 3 seconds
We enter the "Start pressure" configuration.
Display "Start pressure" for 3 seconds
We enter the "Start pressure" configuration.
We view on the display the instantaneous current consumed. If we are viewing this, we then return
to see the pressure
setting of the nominal pump current
intervention of the protection
system following insufficiency
of water, the ART attempts,
with a programmed frequency,
to connect the device until
restoration of the water supply.
See "ART. Automatic reset
function". It must be activated in
point 6 of the ADVANCED MENU
(Ar1).
• Rapid cycles alert: when the
hydro-pneumatic tank has lost
too much air, there are frequent
start-ups and stops. This alert is
activated. It must be activated in
point 2 of the BASIC MENU (rc1).
• Manual reset button .
• 3 types of operation (differential,
reverse and synchronisation).
• Control panel and 3-digit numeric
display, luminous led indicators
and buttons.
• Possibility of configuration:
• Stand-by mode.
• Minimum rapid cycles time.
• Connection and disconnection
delay.