Description Of The Device; Frontpanel - Omnitronic EX-840 Manual Del Usuario

• Additionally, the EX-840 features one more ¼" Mic 1 jack plug on the rearpanel. You can adjust the
microphone volume using the CH-1 fader. Make sure that the LINE 1/MIC 1-switch is set to MIC 1.
• You can connect up to 3 record players using the PHONO 1 sockets, PHONO 2 sockets and PHONO 3
sockets on the rearpanel. You can only control the record player signal after you switched the PHONO /
LINE switches to PHONO. The signal is then controlled via the CH-2, CH-3 and CH-4 faders.
• Connect your tape recorder, tuner, CD-player, cassette deck or all other line signals to the LINE /AUX
sockets on the rearpanel. You can only control the line signals after you switched the PHONO/LINE switches
to line. The signal is then controlled via the respective faders.
• Connect the device to the mains with the enclosed power supply cable.

5. DESCRIPTION OF THE DEVICE

5.1 Frontpanel

(1) PHONO / LINE / AUX-SWITCH
Used to select the input to be sent to the individual channel.
(2) GAIN-CONTROL
Used to set the level of the input signal.
(3) CUE-BUTTON
Use the CUE-button in order to select the channel(s) to be monitored.
(4) TREBLE-CONTROL
Used to increase or lower the HIs of the input signal.
(5) MIDDLE-CONTROL
Used to increase or lower the MIDs of the input signal.
(6) BASS-CONTROL
Used to increase or lower the LOWs of the input signal.
(7) CHANNEL-FADER
Used to adjust the input level of each channel.
(8) X-FADER ASSIGN-BUTTON
Via the X-Fader Assign-button, you can choose to which side of the crossfader you assign the selected
channel.
(9) CURVE ON/OFF-BUTTON
With the Curve On/Off-button, you can between the Crossfader-modes Soft and Sharp. In the Soft-
mode, the Crossfader fades between the channels in a linear, continuous manner. In the Sharp-mode,
the Crossfader works more logarhytmical, i.e. working faster towards the outer edges.
23/47 10007050_V_1_1.DOC