Description Of The Device; Front Panel - Omnitronic CM-742 Manual Del Usuario

5. DESCRIPTION OF THE DEVICE

5.1 Frontpanel
4
2 1
17
3
5
MIC 1
18
MIC ON
OFF TALKOVER
6
7
MIN MAX
19
MIC LEVEL
8
20
MIN MAX
TREBLE
9
21
MIN MAX
MIDDLE
22
10
MIN MAX
BASS
11
2
1
OFF
CHANNEL
ASSIGN
12 13 14 15
(1) 12 V LAMP
BNC-socket for gooseneck-lamp.
(2) POWER SWITCH
Press this button to start operation.
(3) MASTER LEVEL / CUE DISPLAY
The upper display shows the level of the left and right master output.
The lower display shows the level of the channel currently being cued (CUE LED on).
(4) GAIN-CONTROL
Used to set the level of the input signal.
(5) TREBLE-CONTROL
Used to increase or lower the HIs of the input signal.
(6) MIDDLE-CONTROL
Used to increase or lower the MIDs of the input signal.
(7) BASS-CONTROL
Used to increase or lower the LOWs of the input signal.
(8) PHONO / AUX / LINE / MIC-SWITCH
Used to select the input to be sent to the individual channel.
(9) CHANNEL-FADER
Used to adjust the input level of each channel.
(10) CUE-BUTTON
Use the CUE-button in order to select the channel(s) to be monitored.
(11) BEAT-INDICATOR
The LED lights up at every bass-beat of the respective source. As soon as the LEDs flash
synchronously, the speed of the two sources is synchronized.
(12) CURVE ON/OFF-SELECTOR
With the Curve On/Off-selector, you can between the Crossfader-modes Soft and Sharp. In the Soft-
mode, the Crossfader fades between the channels in a linear, continuous manner. In the Sharp-mode,
the Crossfader works more logarhytmical, i.e. working faster towards the outer edges.
(13) CROSSFADER REVERSE-SELECTOR
With this function, you can invert the Crossfader-channels. If inactive, channel 1 is on the left
Crossfader-side; if active, "2-1" channel 1 is on the right Crossfader-side.
(14) CROSSFADER-START-SELECTOR
Activate this function in order to enble crossfader start.
(15) CHANNEL ASSIGN-SELECTOR
With the CHANNEL ASSIGN-selectors, you can choose which channel is to be mixed with another.
EXAMPLE: Set the left CHANNEL ASSIGN-selector to channel 1 and the right switch to channel 2 in
BEAT BEAT BEAT
3
4
16
3
L
– 20 15 10 7
R
L+R
– 20 15 10 7
23
L R
BALANCE
STEREO
MONO
24
MASTER-1
25
BEAT
2 3
1
4 EFFECT
OFF
CHANNEL
ON OFF
ASSIGN
14 26
19
12 V LAMP
1
MASTER LEVEL
L
POWER
5 3 1 0 1 3 5 8 +
R
2
CUE LEVEL
L+R
5 3 1 0 1 3 5 8 +
ON OFF
28
0 10
BOOTH
STEREO MONO
MASTER-2
CUE-LEVEL
27
29
HEADPHONES
CUE CUE
SPLIT MIX
32
31
30