Frigo
13.7
Ford Transit with single seat
A
CAUTION!
For safety reasons when drilling, note the location of existing wiring harness-
es, wires and other components, in particular those which are not visible The
respective components are to be fitted so as not to create a risk of injury for
vehicle occupants (e.g. due to sharp edges) and not to impair the function of
safety features!
➤ Drill where shown in
the picture.
➤ Insert feed nuts into the
holes.
➤ Put the drive unit (1) in place and
attach with bolts and U-washers
➤ Install the battery charger (5) and the control unit (4) on the rear wall.
32
Mounting the drive unit