Basic Instructions - Shurhold Polisher Pro Manual De Instrucciones

Tabla de contenido

Publicidad

1
CHANGING THE BACKING PLATE
To reduce the risk of injury, turn unit
off and disconnect it from the power
source before installing and removing
accessories, before adjusting or making
repairs. An accidental start-up can cause
injury.
a. While holding pad, remove hex bolt with
hex wrench. Remove backing plate.
b. To install the plate, reverse the above
procedure.
2
INSTALLING/REMOVING BUFFING PAD
To reduce the risk of injury, turn unit off and disconnect it from the power source
before installing and removing accessories, before adjusting or
making repairs. An accidental start-up can cause injury.
To install pad or disc on Velcro backing plate, center the pad or disc over plate and
press firmly.
To remove pad or disc from Velcro backing plate, grip pad or disc firmly and
pull from plate.
3
TO START AND STOP TOOL
Make certain that the switch is in the
"OFF" position, and the power
source is the same as that specified
on the tool's nameplate.
First connect the tool to the power source.
To start tool, pull trigger on bottom of tool.
To stop tool, release trigger on bottom of
tool.
Tool may be locked in on position by
engaging trigger lock on left side of trigger.
4

BASIC INSTRUCTIONS

Dual Action Polisher PRO User's Guide

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dual action

Tabla de contenido