Parrot Sequoia Manual De Usuario página 22

Note: once the calibration is complete, a message will tell you
that calibration is complete. Click the link to see the photos taken
during calibration.
Functions of the multispectral sensor button
Use the button to enable/disable burst mode, take photos and enable/
disable Wi-Fi on Sequoia.
Note: Sequoia must be turned on to activate these features.
1 click
2 clicks
4 clicks
Hold down (3 seconds)
Disconnect the multispectral
Press and hold the Sequoia button for 3 seconds to turn it off. The
indicator light goes out. If you disconnect Sequoia while the indicator is
still on the latest photos may be corrupted.
LED properties
Multispectral sensor
Start up
When you turn on Sequoia the LED has the following properties:
18
Take a photo
Enable/disable shots
Enable/disable Wi-Fi
Switch off Sequoia
The sensor is ready to take a
photo.
The sensor needs to be
calibrated.