Installing The Controller; Connecting Electrical Power To The Video Splitter - Dometic PERFECTVIEW VS400 Instrucciones De Montaje Y De Uso

Connecting electrical power to the video splitter

6.2 Installing the operating unit
I
NOTE
Make sure the adhesive surfaces (surface and bottom of the unit) are clean, dry and free
of grease.
Proceed as follows:
➤ Glue the velcro strip to the bottom of the operating unit.
➤ Glue the matching velcro strip to a suitable position in the vehicle (fig. 6, page 5).
➤ Affix the operating unit.
6.3

Installing the controller

Proceed as follows:
➤ Hold the controller at its installation location and mark the four points for the drill holes.
➤ Drill the holes, with a Ø of 3.5 mm, at each of the markings.
➤ Screw the controller in place using the 4 mm self-tapping screws (fig. 7, page 5).
7 Connecting electrical power to the video splitter
7.1 General notes on laying cables
I
NOTE
• As far as possible, use original ducts for laying the cables, or other suitable options
such as panelling edges, ventilation grilles or dummy plugs. If no openings are avail-
able, you must drill holes for the cables. Check beforehand that there is sufficient
space on the other side for the drill head to emerge.
• Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
• Wherever possible, lay cables inside the vehicle, as they are better protected there than out-
side.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
• To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters,
etc.).
• Screw on the plug connections for the connecting cables to protect them against water pene-
tration (fig. 8, page 6).
14
VS400
EN