Battery charging
Once the battery is fully charged, it can be used for up to six (6) hours. The
red LED 4/13 starts flashing once the battery is almost empty. The battery
should now be charged or exchanged. The operating time is dependent on
the listening volume.
18
After use, put the receiver into the charging cradle of the transmitter, without
applying pressure.
Ensure that the receiver is placed correctly. If the receiver is charging, the red
LED 18 at the left side of the receiver is illuminated. The LED 18 is illuminated
green as soon as the battery in the receiver is charged. For first time
operation, it is recommended that the battery be charged for eight (8) hours.
20
An additional battery can be charged in the transmitter. Additional batteries
are available through your Digimax RF distributor.
The additional battery can be plugged into the side charging bay 19. Please
ensure that the sloped side points upward and that you insert it without
applying too much force. The LED 20 is illuminated red when the battery is
charging. If the LED 20 is green, it is ready for use.
We recommend that you exchange the battery in the receiver with the
optional spare battery in the transmitter weekly. This ensures that the batteries
are used regularly and that they achieve a maximum service life.
All batteries lose their capacity over time. This is characterized by a shorter
usage time.
20
19
Cleaning and care
Cleaning the transmitter and the receiver
If the device becomes dusty or dirty, you can clean it with a soft, clean and
damp cloth.
Please disconnect the transmitter from the power supply before cleaning.
Cleaning the silicone ear adapters
You can remove the ear adapters from the fixture. Clean the ear adapters with
mild soapy water. Dry the ear adapters thoroughly and reattach them.
Replacing the silicone ear adapters
The hypoallergenic silicone ear adapters should be replaced if they become
worn or damaged.
New silicone adapters can be ordered from your Digimax RF distributor.
21