Safety Lock In The Neckloop; Listening With The 3.5 Mm Stereo Output; Pairing Of The Transmitter And The Receiver - Clear TV Digimax RF Instrucciones De Servicio

Safety lock in the neckloop

(Neckloop version only)
Please ensure that the safety lock is completely closed in the neckloop to
guarantee proper functioning.
Please ensure the receiver is worn correctly.

Listening with the 3.5 mm stereo output

(Neckloop version only)
+
L
L
BAL CONNECT
TONE
+
R
R
3.5 mm stereo output connector
Important!
The overall operating time of the receiver can be reduced significantly
depending on the accessories connected to the output. We recommend the
purchase of an additional battery to guarantee longer operating time.
16

Pairing of the transmitter and the receiver

If you want to add additional receivers (headsets or neckloops) to the
transmitter, then the new receivers must first be paired with the transmitter.
This is required to ensure that the transmitter and receivers recognize each
other and that they can transmit the encrypted data.
This is only required once for each additional receiver. A maximum of 4
headsets or neckloops can be paired with a transmitter.
If the receiver does not find a transmitter, then the red LED 4 blinks and no
signal will be received.
Please follow the instruction to pair the receiver with the transmitter:
1. Ensure that the transmitter is connected to an electrical outlet and that it
earphones
2. Put the receiver on and ensure that it is switched on– the green LED
3. Press the "Connect" button 27 briefly at the transmitter. The blue LED bar
4. Press the "Connect" button briefly at the headset receiver 5 or neckloop
5. Once the pairing has been completed, the blue LED bar on the
is provided with electricity.
should glow. For the Digimax RF neckloop version switch the neckloop
receiver on.
starts flashing.
receiver 14 to complete the pairing.
transmitter and the receiver status LED stop flashing.
17