IBEA B4-10Ah Manual De Instrucciones página 11

CONNECTING THE BATTERY TO THE HARNESS Fig. 1
Connect the battery to the harness by means of the 3 hook
ends (B). Insert the hook (B) in its housing (A) and lock in,
turning it 90° clockwise.
A
B
CONNECTING THE MACHINE TO THE BATTERY AND
START-UP Fig. 2
Only use original ACTIVE batteries. Connect the motor cable
(A) to the battery connector (B) and lock in, turning the ring
(C) 90° clockwise. Turn the switch to position (1) Fig. 5 Make
sure that the LED on the motor is on and first press the
safety lever (4) and then the accelerator lever (2).
5. CONNECTING
FIG . 1
A
B
FIG . 2
A
C
B
LED COLOUR ON
THE MOTOR
Green
Green / Yellow
Yellow / Red
Red
CONNECTING THE BATTERY CHARGER AND THE
CHARGING LEVEL Fig. 3
Connect the battery charger cable (A) to the battery
connector (B) and the plug (C) in the outlet. The LED on the
battery charger will immediately light up red and then it will
become green if the battery is already fully charged; otherwise,
it will remain red if the battery requires charging. Lithium
batteries do not have any memory effect and therefore can
be charged regardless of their level of charge, and the
recharging process can be interrupted at any time. Batteries
will not be damaged.
FIG . 3
BATTERY PROTECTION SYSTEM
In general, to prevent damage and replacement, Lithium
batteries should never be fully discharged.
11
GB
ENGLISH
BATTERY STATUS
Battery charge from 100% to 80%
Battery charge from 80% to 50%
Battery charge from 50% to 20%
Battery charge from 20% to 0%