Light Emitting Diodes (Led) On Unit; Diagnostic Software - Stihl ADG 1 Manual De Instrucciones

English
If the red light emitting diodes glow /
flash
1 light emitting diode Battery too
glows continuously hot/cold
red:
4 light emitting Malfunction in
diodes flash red battery
1)
Remove battery from analyzer to
cool it down / warm it up. After
cooling down/warming up, restart
the test – insert the battery in the
analyzer.
2)
Electromagnetic malfunction or
fault. Take the battery out of the
analyzer and refit it again – if the
LEDs still flash, the battery has a
malfunction and must be replaced.
16
Light Emitting Diodes (LED)
on Unit
The light emitting diode (1) on the
analyzer can glow or flash green, yellow
or red.
1)
Green continuous light
Battery OK – see also "Light
–
2)
Emitting Diodes (LEDs) on Battery".
Yellow flashing light
Battery type not recognized and not
–
shown on display – but the test can
be continued.
Red continuous light
... indicates the following:
No electrical contact between
–
battery and analyzer – remove and
refit the battery
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Red flashing light
Malfunction in battery analyzer –
–
replace analyzer.

Diagnostic software

STIHL diagnostic software may be used
only in conjunction with STIHL
analyzers.
System Requirements
1
STIHL diagnostic software may only be
installed on a computer that meets the
system requirements. Administrator
rights are required for installation under
®
Microsoft Windows
system administrator if necessary.
Operating System
®
Microsoft Windows Vista
–
®
Microsoft Windows
–
®
Microsoft Windows
–
Software Requirements
®
Microsoft .NET 4.0 or higher
–
®
Adobe Acrobat
–
higher
Hardware Requirements
CPU 2 GHz
–
512 MB free memory
–
a minimum of 250 MB hard disk
–
space
Resolution – SVGA monitor
–
(minimum resolution 1280 x 1024)
USB interface 2.0 or higher
–
CD-ROM or DVD drive
–
®
– contact the
®
or
®
7 or
®
8
®
Reader 9 or
ADG 1