Master SOMBRA 8 Manual De Instrucciones página 14

Do not use the heater directly near a bathtub, a shower, a swimming
pool. In unoccupied premises it is recommended that the heating
system is switched off and isolated from the electrical supply.
5. MAINTENANCE
SOMBRA heaters contain no moving parts and therefore very little
maintenance is required other than to ensure that there is no exces-
sive build-up of dust/dirt on the reflectors or emitters as this can
cause overheating and premature emitter failure (in case, contact the
Technical Assistance Service).
The accumulation of limestone or incrustations reduces the life and
the efficiency of the lamp; it is suggested therefore to avoid the con-
tinued use in presence of water or salt fog. Eventual leavings of salt
water will have to be removed before the use, after having discon-
nected the appliance, by means of soak in sweet water.
6. EMITTER AND SILICON BUMPERS REPLACEMENT
The emitter lasts for around 5000 hours. When changing the lamp,
also the silicon bumpers connected with the lamp must be substi-
tuted. They should be substituted even before if there are signs of
aging. Due to the special sealing and anti-shock design of the heater,
the emitters are not intended to be user replaceable. Please ensure
that all emitters are replaced via the service network.
7. TECHNICAL FEATURES
Power supply
Power
Insulation Class
Protection level
Lamp
Lamp life (hours)
Emission
Range (m )
2
Weight (kg)
Dimensions (mm)
SOMBRA 8
220-240 V ~ 50-60 Hz 220-240 V ~ 50-60 Hz
800 W
I
IP65
Quartz - tungsten wire
5000
IR-A
3÷4
0.9
400x132x90
14
SOMBRA 12
1200 W
I
IP65
5000
IR-A
5÷6
1
470x132x90