Replacing The Double Brake - Verlinde Stagemaker SL10 Manual Del Propietário

For more information, see chapter Tightening torques for the chain hoist.
17. Turn on the power to the chain hoist.
18. Check that the brake works normally.
1.
2.
3.
7.4.5

Replacing the double brake

1. If a load is attached to the hook, remove it.
2. Disconnect the hoist from the main power supply network.
3. Remove the end cover on the brake side.
For more information, see chapter Removing and installing the hoist covers.
4. Check that the brake data of the
replacement brake matches with the data
of the original brake.
You can find the brake data in the sticker
that is attached to the brake.
5. Unplug the brake cables (1) and (2) from
the control board.
Este documento y la información contenida en éste son de propiedad exclusiva de Verlinde S.A.S., constituyen un
secreto comercial no público, confidencial del propietario, y no puede ser ni reproducido, divulgado a terceros,
modificado ni empleado de ninguna otra manera sin el permiso expreso escrito de Verlinde S.A.S. Copyright 2020 ©
Verlinde S.A.S. Todos los derechos reservados.
First test the brake without any load.
Then test the brake with a dynamic test load of 110% (EUR) or 125% (US) of the rated
capacity. Size of the dynamic test load depends on the country regulations.
In the European countries, test the brake also with a static test load of 125% of the
rated capacity.
MANUAL DEL PROPIETARIO
2
1
1. Main brake 2. Secondary brake
3/2020