WINTER
STORAGE
Change
Oil
NOTICE
You must protect
your unit from freezing
temperatures,
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
To protect the unit from freezing temperatures:
1.
Follow steps 1-4 in the previous section After Each
Use.
,
,
Use pump saver, available at Sears, item 74403,
to treat pump. This minimizes freeze damage and
lubricates pistons and seals.
If pump saver is not available, connect a 3-foot
section of garden hose to water inlet adapter. Pour
RV-antifreeze
(antifreeze without alcohol) into
hose. Pull recoil handle twice. Disconnect 3-foot
hose.
While engine is still warm, drain oil from crankcase.
Refill with recommended grade. See Changing Engine
Off.
Protect
Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Sears item
74403, to treat pump. This prevents freeze damage and
lubricates pistons and seals.
NOTICE
PumpSaver is available as an optional
accessory. It is not included with the pressure washer.
Contact your local Sears service center to purchase
PumpSaver.
NOTICE
You must protect
your unit from freezing
temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
4.
Store unit in a clean, dry area.
LONG TERM STORAGE
If you do not plan to use the pressure washer for more
than 30 days, you must prepare the engine and pump
for long term storage.
It is important to prevent gum deposits from forming in
essential fuel system parts such as the carburetor, fuel
filter, fuel hose or tank during storage. Also, experience
indicates that alcohol-blended
fuels (called gasohol,
ethanol or methanol) can attract moisture, which leads
to separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read
and follow all instructions and warnings given on the
PumpSaver container.
Other Storage
Tips
1.
DO NOT store fuel from one season to another
unless it has been treated as described in Protect
Fuel System.
2.
Replace fuel container if it starts to rust. Rust and!
or dirt in fuel can cause problems if it's used with
this unit.
3.
Cover unit with a suitable protective cover that
does not retain moisture.
Protect
Fuel System
Fuel Additive:
Fuel can become stale when stored over 30 days.
Stale fuel causes acid and gum deposits to form in the
fuei system or on essential carburetor parts. To keep
fuel fresh, use Briggs & Stratton® Advanced Formula
Fuel Treatment & Stabilizer, available wherever Briggs
& Stratton genuine service parts are sold.
There is no need to drain gasoline from the engine
if a fuel stabilizer is added according to instructions.
Run the engine for 2 minutes to circulate the stabilizer
throughout the fuel system before storage.
If gasoline in the engine has not been treated with
a fuel stabilizer, it must be drained into an approved
container. Run the engine until it stops from lack of fuel.
The use of a fuel stabilizer in the storage container is
recommended to maintain freshness.
/_ WARNING
Storage covers could cause a fire
_
resulting in death or serious injury.
• DO NOT place a storage cover over a hot pressure
washer.
• Let equipment cool for a sufficient time before placing the
cover on the equipment.
4.
Store unit in a clean and dry area.
22