KNOW YOUR HEDGE TRIMMER
The safe use of this product requires an understanding of the information in this instruction
manual as well as a knowledge of the project you are attempting. Before use, familiarize
yourself with all operating features and safety rules.
Blade Support Rod
TO TURN ON/OFF
1.
Place one hand on the trigger handle
(2). Place the other hand on the
auxiliary handle (4).
2.
Press the lock-out button (3) and hold.
3.
Squeeze the trigger switch (1). The
hedge trimmer will turn ON.
4.
Release the lock-out button (3). The
hedge trimmer will stay on as long as
the trigger switch (1) is squeezed ON.
5.
Release the trigger switch (1) to stop.
IMPORTANT:
accidentally dropped, the hedge trimmer will
turn OFF and the blade will coast to a stop
after several seconds. The hedge trimmer
will then be locked OFF again.
4
OPERATION
If the hedge trimmer is
3
2
1
Auxiliary Handl e
Guard
Battery Pac k
USING THE ROTATING REAR HANDLE
1.
Place the hedge trimmer on a flat and
even surface.
2.
Make sure that the trigger has been
released and the unit is not running.
3.
Press the rotating handle lock button and
begin turning the rear handle. Release
the lock button and turn the handle 90
degrees to either side until it clicks into
place and the button pops out.
4.
To turn the handle back to center, press
the rotating handle lock button again,
turn the handle slightly, release the lock
button and continue turning the handle
until it locks into place.
9
Rotating Handle Lock Button
Lock-Out Button
Trigger Switc h
Battery Pack Latch