Yamaha CD-S3000 Manual De Instrucciones página 15

4
Press ENTER.
The setting value flashes for 3 seconds, then the unit
resumes to normal mode.
To cancel the setting, press CLEAR.
Notes
• As the DPLL bandwidth setting value approaches "Lowest," the
accuracy of the operating clock in the DAC improves, but the
unit may be susceptible to a change in the clock of the external
component. The sound from such a component may more easily
skips.
• As the DPLL bandwidth setting value approaches "Highest,"
the accuracy of the operating clock in the DAC deteriorates, but
the unit is far less susceptible to a change in the clock of the
external component, and the sound from such a component
hardly skips.
■ Setting the AUTO POWER STANDBY
function
The AUTO POWER STANDBY function can be set to
ON or OFF. When set to ON, if the unit is not operated for
30 minutes with no audio signal detected, it automatically
goes to STANDBY mode. When set to OFF, the unit does
not go to STANDBY mode automatically.
1
Open the disc tray and remove any currently-
loaded disc from the unit.
Skip step 1 to 3 if "NO DISC" appears on the
information display.
2
Close the disc tray.
3
Press SOURCE to select "DISC" as the audio
source.
"NO DISC" appears on the information display.
4
Press and hold the
key on the front panel for about 2 seconds to
switch the setting.
(Stop) key: The AUTO POWER STANDBY
function switches to ON, and
"AutoSTBY ON" appears on the
information display.
(Play) key: The AUTO POWER STANDBY
function switches to OFF, and
"AutoSTBY OFF" appears on the
information display.
Notes
• The default setting for the AUTO POWER STANDBY function
is ON.
• This setting is retained even if you turn off this unit.
(Stop) key or (Play)
15
En