Rack Version - Schrack BX01P108007 Serie Manual De Usuario

R
ACK VERSION
The sequence of operations required to convert the BATTERY BOX into the rack version is described
below.
WARNING: for your safety and that of your product, follow the information set out below exactly.
BEFORE CARRYING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE
THAT THE BATTERY BOX IS NOT CONNECTED TO THE ELECTRICITY MAINS, TO
1 - First remove the 4 feet at the base of the
BATTERY BOX. Put the BATTERY BOX
into a horizontal position taking the utmost
care and with a small slotted screwdriver
carefully lift the pin at the centre of the foot.
Once it has been lifted, remove the foot
from the base. Repeat the same operations
for the remaining feet. The exact sequence
to follow is shown at the side:
2 - Once all the feet have been removed, the mask must then be rotated.
Insert the keys provided in the release slots located at the sides of the
mask and exert enough gentle pressure to release it from the BATTERY
BOX, as shown in the figure at the side.
3 - (only for the version with battery charger): The mask is connected to the BATTERY BOX by a
specific cable. The mask must therefore be removed with the utmost care and avoiding violent pulls
or other sharp movements so as to avoid any damage to the LED panel and/or to the actual
BATTERY BOX. DO NOT UNDER ANY CIRCUMSTANCES TRY TO SEPARATE THE MASK
FROM THE BATTERY BOX.
4 - Rotate the mask 90° anticlockwise, carefully insert in the housing and exert gentle pressure near the
release slots until a slight click is heard with the mask remaining in position.
5 - Rotate the BATTERY BOX 90° clockwise taking the utmost care.
6 - At this point, with the BATTERY BOX in a horizontal position, fasten
the handles to the sides with the screws as shown in the figure at the side.
(The handles kit is optional in some versions)
NOTE: The BATTERY BOX is compatible for mounting in standard rack cabinets of 600mm x 800mm or
more (in width). Support brackets (guides with L-shaped support) must be used in the rack
installation due to the weight of the batteries. Installation in the lower part of the rack cabinet is
recommended for the same reason.
THE UPS OR TO ANY OTHER BATTERY BOXES
37
1
I
NSTALLATION
2