Starting Up; Setting Up; Connecting External Devices - Bosch 1 687 023 553 Instrucciones De Funcionamiento

4.4

Starting up

4.4.1

Setting up

!
You will need a clean, level and stable surface on
which to place your PC. Leave a space of at least
8 cm at the rear for the cabling and to provide ade-
quate air circulation.
1. Protect your PC from extremes of temperature and
high humidity. Do not place your PC in direct sun-
light, near hot water pipes or other heat-emitting
objects.
2. Do not place your PC near devices that generate ma-
gnetic fields. Even a telephone placed too close to a
PC can cause problems.
3. Use a socket strip for 240 V AC. We recommend an
overvoltage protection device for guarding against
mains voltage spikes.
4. Ideally, locate your PC where you will not require any
extension cables. Power consumption will increase
sharply if peripherals such as monitors and printers
are required.
Robert Bosch GmbH
Description of unit | 1 687 023 553 - 575 | 19
4.4.2

Connecting external devices

i
The installation instructions apply to all Bosch test
devices in which this PC is installed. Read these
carefully, completely, and observe them.
!
The touchpad (mouse), keyboard and monitor must
be connected to the appropriate interfaces using
properly shielded cables.
2
1
9 8
10
Fig. 8: Connecting external devices
1 PS/2 interface
2 Monitor interface VGA (analog)
3 Network connection RJ45
4 Audio output / Line out
5 Audio input / Line in
6 Microphone
7 USB ports
8 Monitor interface DVI(digital)
9 RS 232 (not supported)
10 PS/2 interface
1. Connect keyboard to keyboard port.
2. Connect mouse to mouse port.
3. Connect monitor video cable to the video interface.
4. If required, connect other external devices.
5. Connect network connection cables for PC, monitor
and any other external devices.
en
3
4
5
6
7
|
1 689 989 076 2012-05-18