iCES IBT-6 Manual De Usuario página 6

Setting up the speaker tower -Attaching the base
1. Take the tower body and base carefully out of the packaging.
2. Take the screws and washers out.
3. Attach the base to the body aligning the holes on the base with the holes on the
tower.
4. Screw the base onto the main unit.
5. Place the tower upright on the floor and it is now ready to use
Power setup
Connect the AC/DC adapter to the DC in socket on the speaker back panel and plug the
adaptor into the mains socket.
Using the remote control
The battery
To get your remote control working intially, pull the clear tab from
the battery compartment located at the bottom of the remote.
If your remote becomes intermittent or you find you have to move
closer the unit to operate, then probably the batteries need to be
replaced.
To replace the batteries, slide the holder out from the base of the
remote. Remove the battery and replace with a 3 volt Lithium
CR2025.
WARNING !
Do not ingest the battery , Chemical Burn Hazard
(The remote control supplied with) This product contains a coin/button cell battery.