Kenwood KSC-256 Manual De Instrucciones página 6

c p
harging rOcedure
Do not use in explosive atmospheres (gases, dust, fumes, etc.).
ATTENTION: Always switch OFF a transceiver equipped with a battery pack before inserting
the transceiver into the charger.
 Ensure that the Power switch is in the off (
located on the rear of the charger.
 Plug the AC plug into an AC outlet.
 Press the Power switch to turn the charger ON.
 Slide a battery pack or a transceiver equipped with a battery pack into the charging slot.
• The indicator lights red and charging starts.
• Make sure the metal contacts of the battery pack mate securely with the charger
terminals.
5 When charging is completed, the indicator lights green. Remove the battery pack or the
transceiver from the charging slot and turn the power off.
• When the charger will not be used for a long time, unplug the AC cord from the AC outlet.
E type
To
AC outlet
T type
AC cord
Charger Status Table
Indicator Color
Red
The LED will blink
red or will not light
Green and
Blinking Orange
Green

Power switch
A battery pack
or a transceiver equipped with a battery pack
charging slot and charging has started.
The battery pack is defective or the battery pack contacts are not
properly mated with those of the charger.
The temperature of the battery pack has not satisfied the charging
start temperature. In this instance, remove the battery until its
temperature increases, then recharge it.
Charging is completed; remove the battery pack or the transceiver
from the charging slot.
) position. Plug the AC cord into the AC inlet
Meaning
is in the