Troubleshooting - Salvador Escoda LXDY3 Manual Del Usuario

SALVADOR ESCODA S.A.
www.salvadorescoda.com
7. Trouble shooting
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestion be-
low to see if you can solve the problem before calling the service centre.
Problem
The heater does not operate, even
when it is pluged in and the
switch, thermostat are switched
on.
The heating element glowing
The appliance didn't heat up, only
ventilator worked
Abnormal noise
10
®
Provença, 392 pl. 1 y 2
08025 BARCELONA
Tel. 93 446 27 80
Fax 93 456 90 32
Possible cause
The plug is loose, bad connection,
No power in socket outlet.
The input voltage is too high or
too low
The air inlet grill is blocked
The switch was not put at heating
setting
The thermostat operated
The Non-self resetting cut-out
operated
The appliance is not stands
uptright
USER MANUAL INDUSTRIAL FAN HEATER LXDY3
CATÁLOGO TÉCNICO
MANUALES, CATÁLOGOS Y HOJAS TÉCNICAS: EN NUESTRA WEB
Treatment
Pull out the plug, check the
connection of the plug and socket.
Then connect again.
Insert the plug in a proper socket.
Use proper supply according to
the rating on the lable.
Keep the heater far away from
articales like curtain, plastic bag,
paper and other things which can
cover the inlet or can be easily
cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if
there is open/close voice. If there
is no click and the thermostat is
not damaged, the heater will
automatic switch on when the
appliance cooled down.
Disconnect the power, held the
stick and insert it in the reset hole
on the control panel, press down
the reset button and connect the
circuit.
Put the heater on a level surface