Cleaning And Maintenance; Using Instructions - Salvador Escoda LXDY3 Manual Del Usuario

SALVADOR ESCODA S.A.
www.salvadorescoda.com

5. Cleaning and Maintenance

5.1 Before cleaning the appliance, disconnect it from
the socket and let it cool down. The enclosure is
easily to get dirty, wipe it often with soft sponge.
For every dirty parts, wipe with a sponge dipped in
<50°C water and mild detergent, then dry the hea-
ter enclosure with clean cloth. Becareful not to let
the water enter the appliance inner. Don't splash
water onto the heater, never use solvent like gaso-
line, isoamyl acetate toluene etc. to clean the hea-
ter, in order to protect the enclosure.

6. Using Instructions

6.1 Connect the heater power socket.
6.2 Position the fan heater so that it stands upright on
a firm surface and at a safe distance from wet en-
vironments and flammable objects.
6.3 Connect the fan heater to the mains.
6.4 Set the thermostat knob to the MAX and let the
heater operate with full power.
6.5 The fan heater will switch on when the heating se-
lector is set to one of the power settings.
6.6 Once it reaches the required temperature, heating
element will stop working but fan also working.
Once the temperature decreased, the heating el-
ement will be working.(Its with inside 75°C ther-
mostat device)
6.7 The fan heater now starts and stops automatically
and thus keeps the room temperature constant.
USER MANUAL INDUSTRIAL FAN HEATER LXDY3
®
Provença, 392 pl. 1 y 2
08025 BARCELONA
Tel. 93 446 27 80
Fax 93 456 90 32
5.2 Clean the cord and plug, dry and pack it in a plastic
bag.
5.3 When you store the heater, let it cool down first,
keep it dry. Then cover it with a plastic bag, put in a
packing box and store it in a dry, ventilated place.
6.8 Before off heater, please turn the thermostat to
OFF position and turn the heating knob to Fan or
OFF, let the appliance cool down for two minuts.
6.9 Time-delay thermostat cut-off: If you forgot to turn
the thermostat to OFF position before off the
heater, thermostat cut-off and fan will be working
when the temperature of front grill of heater is
near 50° or 45° . When temperature reduced to
about 45° or 40° , the thermostat cut-off and fan
will stopped working itself. It will cool heater. (It's
with inside 45° time-delay thermostat device )
6.10 This series heater can adjusted angle about 20°
according to your requirement by screw on two
side panel
6.11 After using, turn off the heater firstly, pull out the
plug.
CATÁLOGO TÉCNICO
MANUALES, CATÁLOGOS Y HOJAS TÉCNICAS: EN NUESTRA WEB
9