Using The System - ECG CDR 1000 U Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 84

USING THE SYSTEM

Using the remote control
Before using the remote control you must first remove from the battery compartment the plastic tab,
which prevents draining of the battery.
When the functions of the remote controller become unreliable or the range decreases, replace batteries.
Point the remote controller to the IR sensor on the device and press the required function button.
The remote control range is approximately 6 meters, but using it at an angle reduces the remote control
range.
Do not expose the remote control sensor to strong light sources and make sure that there are no obstacles
between the remote controller and the sensor. Otherwise, the function might fail.
Setting the time
Press briefly the button TIME/PROGRAM in the standby mode. The display will flash time format (12H or
1.
24H).
2.
Press the button BACK or NEXT to select 12H or 24H format and press TIME/PROGRAM to confirm the
selection.
GB
The hours "XX" start flashing. Press the button BACK or NEXT to set the hour and confirm by pressing
3.
TIME/PROGRAM.
4.
The minutes "XX" start flashing. Press the button BACK or NEXT to set minutes and confirm by pressing
TIME/PROGRAM.
Set alarm (turning the device on/off)
When you successfully set the clock, enter the menu settings by pressing and holding the button TIME/
1.
PROGRAM in such a way that the display shows "ON' .
2.
The display starts flashing the time when the device should start "00:00". Press BACK or NEXT to set the
device's start time and confirm by pressing the button TIME/PROGRAM.
The display flashes the device's shutdown time "00:00". Press BACK or NEXT to set the device's shutdown
3.
time and confirm by pressing the button TIME/PROGRAM.
Now you can set the music source. Press BACK or NEXT to select Radio/USB/CD/AUX and confirm by
4.
pressing the button TIME/PROGRAM.
Adjust the volume. Press BACK or NEXT to set the volume and confirm by pressing the button TIME/
5.
PROGRAM.
Listening to the radio
1.
Press the power button to start the device.
2.
Press repeatedly the button FUNCTION to select the radio mode (the display shows RADIO).
If you want to start auto search of the stations, hold the button NEXT for several seconds. If you want to
3.
tune a radio station manually, press briefly and repeatedly the button NEXT.
Press PLAY/PAUSE to start the automatic search of all stations and their saving in the memory.
4.
5.
The external FM antenna is a directional antenna. When receiving FM broadcast, extend it fully and set it in
the direction that ensures the best reception.
6.
Set the volume to a comfortable level.
7.
Turn off the device by pressing the power button.
Storing the favourite radio stations and their recall from memory
If you want to save the tuned radio station in memory while listening to it, press the button TIME/
1.
PROGRAM. The display starts flashing the preset number.
2.
Press repeatedly P-DN or P-UP to select the preset number (P01–P30) under which you want to save the
station.
Press TIME/PROGRAM to save the station under the selected preset number.
3.
4.
You can store other stations in the memory by repeating the preceding steps..
44

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cdr 1000

Tabla de contenido