Master Section Description; Usb Recorder Description - Phonic POWERPOD 410 R Manual Del Usuario

MASTER SECTION DESCRIPTION

6. DIGITAL DELAY
The signal from the input channels, processed by the built-in digital
delay will feed to the master output. There are three knobs here
to control the effect of digital delay.
TIME - This knob adjusts the internal time of the delays; turn to the
right to increase the interval time between two delays.
REPEAT - To increase the rate of the delays, turn this knob to the
right. You will hear the signal repeat at a faster rate.
7. POWER INDICATOR
When the power switch on the rear panel is turned on, this indica-
tor will illuminate.
8. TAPE IN/USB IN CONTROL
This level control adjusts the playback level sent from the USB
recorder's playback function to the main mix. In addition to this,
it also controls the input level taken from the RCA Tape Inputs
on the rear of the Powerpod 410R.
9. MASTER CONTROL
This adjusts the final level of the Main bus. It controls the Main
bus signal which is output to the speakers.
6
8
9
POWERPOD 410
R

USB RECORDER DESCRIPTION

The USB Recorder's source signal is taken directly from each
individual input channel. While the recordings are indeed in stereo,
they are also limited by the Powerpod 410 R's circuitry, which is
mono rather than stereo. When playing back a signal, the signal
will pass through the USB In control and then is sent directly to
the main mix. Playback of WAV and MP3 with bit rates of up to
320 kbits per second is possible.
10.
This 3-digit display will display the track number currently being
played. It also offers play, pause and record indicators to the left
of the display. When in playback mode, the screen will indicate
the type of file the unit is currently playing: WAV or MP3.
11.
Connect your USB flash drive to this input. Once a drive is con-
nected, the files will initiate and the first track will appear paused
on screen. Users are advised to format their USB memory sticks
with the FAT-32 file system.
12.
Push this button to start recording mode. When recording mode
is initiated, the next available track number (after any previously
recorded tracks) will appear on screen and recording mode will be
initiated in pause. Push the Play/Pause button to start recording.
Recording is only possible when an appropriate USB memory
7
card is inserted into the USB port.
13.
Pushing these buttons will allow users to skip back and forwards
between tracks in sequence. Please note that these buttons can-
not be held down to fast-forward/rewind through tracks.
14.
Push this button to start and stop playback and recording of the
currently displayed track. Starting a track after it is paused will
resume the track from the point at which it was paused (in both
record and playback mode). When in recording mode, push and
hold this button to finalize recordings. When in playback mode,
pushing and holding this button will revert back to the first track
on the USB memory stick.
DISPLAY
USB PORT
RECORD BUTTON
BACK/NEXT BUTTONS
PLAY/PAUSE BUTTON
13
12
11
14
10
5