Akiyama AW-05 HCT-054 Manual De Instrucciones página 7

AW-05
Akiyama AW Series has been specially developed for both indoors and outdoors with weather-resistant materials. The
cabinet is made ofABS plastic, the front grille is metal and powder lacquered.
NOTE: Before plugging in and turning on, it is important to remember the Golden Rule of audio:"LAST ON, FIRST
OFF".Translated, this means that when turning on your system,you should always turn your power amplifiers or powered
monitors on LAST, and when turning your system off, turn your power amps off FIRST. This helps avoid any loud pops
caused by inrush current at power up, which can some-times damage loudspeakers.
1. Before connecting, make sure that the power of all your systems components are turned off.Also,make sure that your
power amplifier volume controls and the main left and right faders of your mixer are turned all the way down.
2. Connect the cables to your microphones and instruments, or a CD player, to your mixer.
3. Switch on the power of the mixer, instruments and/or CD player,and then switch on your power amplifier.
4. While speaking into the mic ( or playing the instrument of CD ), raise the mixers main Left and Right faders to the
"0"position. Be sure that the mixer's output meter are not clipping. If they are,adjust the mixer volumes down until the
signal cleans up.
5. Now, slowly raise your power amp controls until you reach the desired listening
Level.
MOUNTING / PLACING
Akiyama AW Series may be mounted for use with
1.39"standard speaker stands, or mounted parallel to the
mounting surface, or on a wall.
1. Using the 1.39"standard speaker stand;
2. Using the holes on the speakers back panel;
3. Using the bracket which balanced supply or suspended
SOME USEFUL HINTS
from a ceiling;
Fasten screws on a firm wall or wall support as shown in
the figure and set the mounting holes onto the protruding
screws.
Make sure that the screws are caught securely at a narrow
part of the holes.
AW-05
INTRODUCTION
1
1